Reflex 75T Conventional Flue User Installation Manual

19
Installation Instructions
5. Masonry Chimney Installation
5.1 There are 2 methods of installation into a masonry chimney:
5a. Edge nish Installation.
5b. Installation with a decorative front.
Carefully read the relevant section for the installation
method required.
5.2 This appliance is designed so that non-combustible board
can be taken right up to the edge of the ange.
5a. Edge Finish Installation
5a.1 This method is designed so that non-combustible board can
be taken right up to the edge of the ange of the appliance.
5a.2 Fix the self adhesive foam seal around the back of the xing
ange of the appliance.
5a.3 Prepare the ue connection using the chosen method
described in Section 2.
5a.4 Connect the ue and install the appliance into the aperture.
At the same time ensure that the gas pipe passes through
the silicon panel at the back of the appliance.
Provide electric services into the void on the right hand
side.
It is necessary to be able to disconnect the
appliance from the mains electrical supply after
installation.
This may be achieved by an accessible plug or by
incorporating a switch into the fixed wiring in
accordance with the rules in force.
5a.5 Slide the metal plate, previously removed, over the gas pipe
and secure with a screw, see Diagram 15.
15
Screw
Metal Plate
Gas Supply
5a.6 Secure the appliance through the 6 xing holes using the
screws provided, see Diagram 16.
16
5a.7 Build the chimney breast up to coincide with the edge,
allowing for the front to be skimmed level.
5a.8 Fit non-combustible board to the chimney breast around the
appliance, using the distance to combustibles detailed in
Diagram 17.
17
Min
400mm
Bottom of
Appliance
Min 200mmMin 200mm
5a.9 Fit plasterboard to the remaining of the chimney breast
front.
5a.10 Apply a heat resistant plaster around the appliance using
the distance to combustibles detailed in Diagram 17.
5a.11 Apply a plaster nish to remaining chimney breast front.
5b. Installation with a
Decorative Front
Mantels, Hearths & Slips
If tting this appliance with a decorative surround it
will be necessary to install the appliance with a Hearth
and Slip set.
The hearth must have a minimum depth of 225mm.
It is essential to ensure that a height of 123mm is
maintained from the nished oor to the bottom edge
of the viewing area.
Read these instructions in conjunction with the
manual supplied before installation.
5b.1 Fix the self adhesive foam seal around the back of the xing
ange of the appliance.
5b.2 Prepare the ue connection using the chosen method
described in Section 2.