Reflex 75T Balanced Flue User Installation Manual

51
REPLACING THE LED CIRCUIT
There are 3 LED boards, which can be replaced individually.
Driver
Front LED 1
Front LED 2
Rear LED bar
THE LED'S ARE FRAGILE. HANDLE WITH CARE.
ONLY HOLD THE LED BOARDS BY THE EDGES TO
AVOID CONTACT WITH THE TOP OF THE LED'S.
AVOID CATCHING ANY DELICATE WIRES WHEN
REPLACING THE SCREWS.
FRONT LED BOARDS
There are two LED boards located on a shelf below the top of the
Control Assembly.
Remove the Main Control Assembly for access.
1
2
Remove the 2 screws holding the LED boards to the Control
Assembly by inserting a screwdriver through the gap previously
covered by the glass bracket.
3
The boards can now be replaced.
NOTE: Each board has the wiring direction marked as IN or OUT
on each end to ensure the replacement boards are wired correctly.
REAR LED BAR
4
Pipes and wires removed for clarity
5
Pipes and wires removed for clarity
1
2
6
1
2
DRIVER
The driver is located in the underside of the Main Control Assembly
next to the latching Solenoid.
This is a non-serviceable part.