Reflex 75T Balanced Flue User Installation Manual

27
MASONRY INSTALLATION
There are 2 methods of installation into a masonry chimney:
Edge nish Installation.
Installation with a decorative front.
Carefully read the relevant section for the installation method required.
This appliance is designed so that non-combustible board can be taken right up to the edge of the ange.
It is necessary to be able to disconnect the
appliance from the mains electrical supply after
installation.
This may be achieved by an accessible plug or
by incorporating a switch into the xed wiring in
accordance with the rules in force.
EDGE FINISH INSTALLATION
1
Silicone
Strip
2
3
x6
Fit non-combustible board to the chimney breast around the
appliance, using the distance to combustibles detailed
4
Min
200mm
Min
150mm
Min: Bottom of the
appliance
Min
200mm
Fit plasterboard to the remaining of the chimney breast front.
Apply a heat resistant plaster around the appliance using the
distance to combustibles detailed.
Apply a plaster nish to remaining chimney breast front.