Harmony 10 Quick Start Guide

Decreasing the Flame Height:
To decrease flame height or to set the appliance to pilot
flame press and hold the button.
NOTE: While pressing a button a symbol indicating
transmission appears on the display. The receiver
confirms transmission with a sound signal.
Thermostatic Mode (Automatic)
1.6 To select the Thermostatic mode press the button.
The preset temperature will show briefly then the current
room temperature will be displayed.
Setting the temperature:
Press and hold the button until the temperature
display flashes.
Adjust the temperature by pressing the or button.
Press the button to confirm the temperature.
NOTE: If you set a temperature that is beneath the
current room temperature, the fire automatically
switches to PILOT (Stand by).
Exiting Thermostatic Mode:
Press the button to exit Thermostatic mode.
Press the or button to enter Manual Mode.
Press the button to enter Program Mode.
Press the button to enter Eco Mode.
Program Mode (Automatic)
1.7 To select the Program mode press the button.
The set temperature for the On time is the one set in
Thermostatic Mode. Changing the thermostat temperature
changes the temperature in Program mode.
Default Settings
The On time (Thermostatic) Temperature is 21°C (70°F).
The Off time Temperature is '--' (Pilot flame only).
Temperature Settings
Press the button and hold until the display flashes
ON and set the temperature (See Thermostatic Mode) is
displayed.
Press the button or wait until OFF is displayed
and the temperature flashes.
Adjust the temperature by pressing the or button.
Press the button to confirm the temperature or wait.
NOTE: The On (Thermostatic) and Off set temperature is
the same for each day.
Day Setting:
Press the button again, ALL Flashes. Press
or button to choose between ALL, SA,SU, 1, 2, 3, 4, 5,
6, 7.
Press the button to confirm.
ALL Selected
ON TIME SETTING (PROGRAM 1):
, 1 ON displayed, ALL is displayed shortly and hour
flashes.
Select the hour by pressing the or button.
Press the button to confirm. , 1 ON displayed, ALL
is displayed shortly and minutes flashes.
Select the minutes by pressing the or button.
Press the button to confirm.
OFF TIME SETTING (PROGRAM 1):
, 1 OFF displayed, ALL is displayed shortly and hour
flashes.
Select the hour by pressing the or button.
Press the button to confirm. , 1 OFF displayed,
ALL is displayed shortly and minutes flashes.
Select the minutes by pressing the or button.
Press the button to confirm.
NOTE: either continue to PROGRAM 2 and set on and
off times or stop programming at this point and
PROGRAM 2 remains deactivated.
PROGRAM 1 and PROGRAM 2 use the same On
(Thermostatic) and Off temperatures for ALL, SA:SU
and Daily Timer (1, 2, 3, 4, 5, 6, 7). Once a new On
(Thermostatic) and/or Off temperature has been set,
that temperature becomes the new default setting.
If ALL, SA:SU or Daily Timer are programmed for
PROGRAM 1 and PROGRAM 2 On and Off times these
become the new default times. The batteries must be
removed to clear PROGRAM 1 and 2 On and Off times
and temperatures.
SA:SU or Daily (1, 2, 3, 4, 5, 6, 7) selected
Set On and Off time using the same procedure as 'ALL
Selected' (above).
SA:SU: Set On and Off time for both Saturday and Sunday.
Daily Timer: Unique On and Off times might be set for a
single day of the week, for multiple days of the week, or for
every day of the week.
Wait to finish setting.
PR2339 Thermostatic Quick Start Guide Issue 1.indd 4 17/11/2016 08:02