Harmony 10 Quick Start Guide

1.2 There are 4 different modes available for controlling and
operating the appliance:
1. Manual Mode
2. Thermostatic Mode (Automatic)
3. Program Mode (Automatic)
4. Eco Mode (Automatic)
1.3 In MANUAL MODE you can:
— turn on the main burner using the button.
— regulate the flame from high to low and back.
— turn off the burner leaving just the pilot burning.
In THERMOSTATIC MODE (Automatic) you can:
— set the room temperature so the thermostat in the remote
automatically maintains that temperature.
In PROGRAM MODE (Automatic) the fire:
— turns on and off according to the set time periods.
— automatically regulates the room temperature during the
set periods.
In ECO MODE (Automatic) the fire:
— modulates the flame height between high and low in
response to room temperature. One cycle lasts for 20
minutes.
NOTE: When operating the fire in Thermostatic or
Program mode, the pilot remains lit and the fire then
automatically switches on to bring the room to the set
temperature whether or not you are in the room.
NEVER LEAVE ANY COMBUSTIBLE MATERIALS
WITHIN 1 METRE OF THE FRONT OF THE APPLIANCE.
Turning the appliance Off (Standy By)
1.4 Press and hold the button to turn the appliance off.
NOTE: There is a 5 second delay before the next ignition is
possible.
Manual Mode
1.5 To turn the fire on press the button until two short
signals and a series of blinking lines on the handset confirm
the start of the ignition sequence and there will be a clicking
sound as the valve opens on the appliance.
Standy By (Pilot Flame) Mode:
Press and hold the button to set the appliance to pilot
flame only.
FOR SAFETY, YOU MUST WAIT 30 SECONDS BEFORE
LIGHTING THE FIRE AGAIN.
Increasing the Flame Height:
To increase flame height press and hold button.
Exiting Program Mode:
Press the , or button to enter Manual Mode.
Press the button to enter Thermostatic mode.
Press the button to enter Eco Mode.
Eco Mode
The Eco Mode allows the fire to modulate between the High
and Low fire positions to give a live fire effect.
Turning the Eco Mode on.
Press the button to enter Eco Mode. is
displayed.
Turning the Eco Mode off.
Press the button to exit Eco Mode. will
disappear.
Designated High and Low fires
NOTE: Backlight must be on for high and low fire
double click operation.
To go to Low fire, double click the button. LO is
displayed.
Flame goes to high fire first before going to Low fire.
To go to Hi fire, double click the button. HI is
displayed.
Dual Burner Function
Upon ignition Burner 1 is on and Burner 2 is in the last
setting. Both sides can be activated or controlled using the
Dual Burner Function.
Press and hold the button to enter Dual Burner
Function and turn on burner 2. is displayed.
Press and hold the button to exit Dual Burner Function
leaving only burner 1 in operation . will disappear.
Light Operation
Turning the light on.
Press the button to operate. is displayed.
The light is on at preset level.
Turning the light off.
Press the button to turn off. disappears.
NOTE: The light works independantly of the Pilot
flame. If you want the light on but no flame press the
button to operate.
PR2339 Thermostatic Quick Start Guide Issue 1.indd 3 17/11/2016 08:02