Reflex 105 Multi-Sided Installation Instructions 1

7
Select the minutes by pressing the or button.
Press the button to confirm.
NOTE: either continue to PROGRAM 2 and set on and
off times or stop programming at this point and
PROGRAM 2 remains deactivated.
PROGRAM 1 and PROGRAM 2 use the same On
(Thermostatic) and Off temperatures for ALL, SA:SU
and Daily Timer (1, 2, 3, 4, 5, 6, 7). Once a new On
(Thermostatic) and/or Off temperature has been set,
that temperature becomes the new default setting.
If ALL, SA:SU or Daily Timer are programmed for
PROGRAM 1 and PROGRAM 2 On and Off times these
become the new default times. The batteries must be
removed to clear PROGRAM 1 and 2 On and Off times
and temperatures.
SA:SU or Daily (1, 2, 3, 4, 5, 6, 7) selected
Set On and Off time using the same procedure as 'ALL Selected'
(above).
SA:SU: Set On and Off time for both Saturday and Sunday.
Daily Timer: Unique On and Off times might be set for a single day
of the week for multiple days of the week or for every day of the
week.
Wait to finish setting.
Exiting Program Mode:
Press the , or button to enter Manual Mode.
Press the button to enter Thermostatic mode.
Press the button to enter EcoFlex Mode.
ECOFLEX MODE
Turning the EcoFlex Mode on.
Press the button to enter EcoFlex Mode. is displayed.
Turning the EcoFlex Mode off.
Press the button to exit EcoFlex Mode. will disappear.
DESIGNATED HIGH
AND LOW FIRES
NOTE: Backlight must be on for high and low fire
double click operation.
To go to Low fire, double click the button. LO is displayed.
Flame goes to high fire first before going to Low fire.
To go to Hi fire, double click the button. HI is displayed.
DUAL BURNER FUNCTION
Upon ignition Burner 1 is on and Burner 2 is in the last setting.
Both sides can be activated or controlled using the Dual Burner
Function.
Press and hold the button to enter Dual Burner Function and
turn on burner 2. is displayed.
Press and hold the button to exit Dual Burner Function
leaving only burner 1 in operation . will disappear.
LIGHT/DIMMER OPERATION
Turning the light on.
Press the button to operate. is displayed.
The lights on at preset level.
SETTING:
Press the button and hold until is flashing.
To adjust the lighting between 20 % and 100% press the or
button.
To confirm setting either press the button or wait ( is
displayed).
Turning the light off.
Press the button to turn off. disappears.
NOTE: The light works independently of the Pilot
flame. If you want the light on but no flame press the
button to operate.