Reflex 105 Multi-Sided Installation Instructions 1

Undo the Injectors individually.

Replace with the correct size Injector.

See table on Page 12.

NOTE: DO NOT OVERTIGHTEN.

Use thread sealant Loctite 572 when replacing Injectors.

Repeat for the remaining Injectors.

Check for leaks.

CROSS LIGHTING INJECTOR

Remove the Log Burners and Main Control Assembly.

Turn the Main Control Assembly over to access the components on

the underside.

Remove the injector pipe by loosening the two nuts.

Undo the nut from the Cross Lighter.

Turn the Main Control Assembly over.

Withdraw the Cross Lighting bar from the Control Assembly.

The Injector is screwed into the bottom of the bar.

Replace with the correct size Injector and ret all components in the

reverse order.

Ensure the left and right hand sides of the Burner engages in the

bracket slots.

NOTE: The LH bracket is part of the Pilot bracket.

LH Bracket

RH Bracket

Check for leaks.

LATCHING SOLENOID

Remove the Main Control Assembly.

Remove the cradle holding the rear LED's to access the pipe work

for the solenoid.

Undo the 3 nuts shown and free the solenoid from the pipe work.

(Beneath Lip)