Reflex 105 Multi-Sided Installation Instructions 1

53
THE LED'S ARE FRAGILE. HANDLE WITH CARE.
ONLY HOLD THE LED BOARDS BY THE EDGES TO
AVOID CONTACT WITH THE TOP OF THE LED'S.
AVOID CATCHING ANY DELICATE WIRES WHEN
REPLACING THE SCREWS.
Remove the Log Burners, Fuel effect, and Mesh tray.
1
2
Disconnect the LED Mains Lead Plug from the Module.
LED wires
Module wires
3
4
5
1
2
The LED circuit consists of three components, which can be
individually changed, these are:
Front LED Boards.
Rear LED Bar.
Driver.
LED boards
NOTE: Each board has the wiring direction marked as IN or OUT
on each end to ensure the replacement boards are wired correctly.
Repeat for each front LED board.
LED Driver
Remove the screw in the center of the Driver lip.
Carefully lift the Driver (with cables) off the control assembly to
remove.
Replace in reverse order ensuring the components are in the
correct configuration.
ENSURE NO WIRES ARE TRAPPED WHEN
REPLACING THE COMPONENTS.
REPLACING THE MODULE
1