Reflex 105 Multi-Sided Installation Instructions 1

51
REMOVING THE LOG BURNERS
AND MAIN CONTROL ASSEMBLY
Remove the Front Glass.
Remove the Fuel Effect.
1
2
4
2
1
3
3
4
WHEN REPLACING THE MESH TRAY TAKE CARE NOT TO
DAMAGE THE LOG BURNER BRACKETS, PILOT AND CROSS
LIGHTER. REPLACE THE FRONT SCREWS FIRST BEFORE
TIGHTENING THE REAR SCREWS.
5
6
Turn the gas supply off at the isolation device.
HAVE YOU ISOLATED THE GAS SUPPLY?
Disconnect the isolating device from the appliance inlet pipe (A) to
isolate the gas supply.
7
Remove the remaining screws securing the Main Control Assembly
to the rebox.
8