Reflex 105 Multi-Sided Installation Instructions 1
50
To replace the glass panel, replace in reverse order.
Ensure that the brackets engage with the glass panel and the
glass is pressed rmly into position.
ENSURE THAT ALL GLASS PANELS ARE FLUSH AND THAT
THERE ARE NO GAPS BETWEEN PANELS.
UNDER NO CIRCUMSTANCES SHOULD THE
APPLIANCE BE USED IF ANY OF THE GLASS
PANELS ARE LOOSE, DAMAGED, OR MISSING.
Replace the lower and side trim.
REMOVING THE FUEL EFFECT
The fuel effect consists of 6 different components.
To avoid damage Logs A, B, C, F and M should be removed in the
following order and placed on a dry, clean surface.
Remove Log M from the groove in Log A.
Remove Log B from the Log Burner.
B
F
M
C
Remove Log C & F from the Log Burners.
Slide Log A backwards, from under the centre Log Burner, to
remove.
A
Remove the remaining components:
1. Large Embers J & H
2. Ember G (x3) & Ember L
3. Shale Effect
4. Amber Effect
Keep each component separate for ease of replacing.
When replacing the fuel effects see Installation Instructions
Section for layout instructions.
Loosen and slide side glass bracket.
1
2
7
Repeat for the 2 upper Brackets and 2 lower Brackets.
62
Upper Side Brackets
Lower Side Brackets
8
With the brackets disengaged, carefully slide the side glass panel
forward, lift, and swing the bottom out to remove.
Place the glass carefully to one side.
1.
2.
3.
9
The side glass does not need to be removed to
service the appliance.
It is recommended to leave the Side Glass in situ
unless absolutely necessary.
The glass panel must be retted to the appliance following cleaning
or servicing.