Reflex 105 Multi-Sided Installation Instructions 1

49
GENERAL
All main components can be replaced without removing the
appliance from its installation.
DISCONNECT MAINS ELECTRICAL SUPPLY AT THE
ACCESSIBLE PLUG OR DEDICATED SWITCH BEFORE
SERVICING THE APPLIANCE.
IT IS ESSENTIAL THAT THE GAS SUPPLY TO THE APPLIANCE
IS TURNED OFF AT THE ISOLATION DEVICE BEFORE
PROCEEDING FURTHER.
It will be necessary to remove the burners and the fuel bed before
any of the main components can be serviced.
The Power Module and the Wi-Fi Receiver can be serviced by
removing the decorative trim and lower glass retaining bracket.
DURING SERVICING OF THIS APPLIANCE IT MAY
BE NECESSARY TO CUT CABLE TIES IN ORDER TO
ACCESS AND REMOVE SOME OF THE PARTS.
THESE MUST BE REPLACED WHEN
REASSEMBLING THE APPLIANCE.
AFTER SERVICING ENSURE THAT ALL
CONNECTIONS ARE REPLACED BEFORE
REPLACING THE MESH TRAY.
REMOVING THE GLASS
1
2
Loose the front glass clamps.
Top Pivot Brackets
Bottom Pivot Brackets
3
4
Top Support Bracket
Bottom Support Bracket
Gap
Gap
5
Lift out the front glass.
6
1
2