Reflex 105 Multi-Sided Installation Instructions 1

43
TURNING THE APPLIANCE OFF
(STANDBY)
Press and hold the button to turn the appliance off.
NOTE: There is a 5 second delay before the next ignition is
possible.
TROUBLESHOOTING
IMPORTANT: In the unlikely event that the handset
fails to communicate correctly with the appliance
it may be necessary to turn off the gas supply
at the isolation valve until any problems can be
resolved.
The gas meter and isolation valve can be located
outside in a meter box, under the stairs, beneath
the kitchen sink or in the garage. Whilst this list
is not exhaustive, it is important to be able to
identify the location of the valve in case of any
gas emergency.
To turn off the gas supply, simply turn the handle
so the lever is at 90 degrees to the upright gas
pipe.
If you smell gas, open doors and windows and
never operate any electrical switches.
Immediately call the Gas Emergency Services on
0800 111 999.
MYFIRE WI-FI INSTALLATION
BEFORE UNDERTAKING ANY WORK SWITCH OFF THE
APPLIANCE AND ISOLATE THE POWER SUPPLY ENSURING
THERE IS NO POWER TO THE APPLIANCE.
Remove the Front Glass.
1
2
Position the Wi-Fi module in the Wi-Fi module bracket.
Module Bracket
Receiver Location
3
The receiver is located beneath the Main Control Assembly, close
to the pilot area.
Using long nose pliers connect the other end of the module lead to
the receiver.
Note: Do not force the connector into position, ensure the
connector is at the correct orientation before inserting.
Ensure the module lead runs underneath the front panel spacer.
Front Panel removed for clarity
Front Panel Spacer
4
This should complete the wiring circuit as shown.
Wi-Fi
Router
Interrupter Leads
Wi-Fi Module
AUX Lead
Valve Lead
Ignition
Cable
Connecting Wire
Lighting
Module
Mains
Lead
Smart Device
Wall Switch Lead
(not applicable)
5
NOTE: Ensure none of the wires are snagged or caught on
any internal components.