Reflex 105 Multi-Sided Installation Instructions 1

NOTE: Ensure the 2 brackets at the rear are pushed

as far back as possible before tightening.

NOTE: Some burners are pre-tted with Aeration plates. These

are non-serviceable and MUST NOT be altered.

ARRANGEMENT OF FUEL BED

COMPONENTS

TAKE CARE NOT TO SPILL THE FUEL EFFECT INTO THE

PILOT AREA.

ONLY GENUINE GAZCO PARTS CAN BE USED IN THIS

APPLIANCE.

Use the entire bag of supplied Amber Effect.

The Shale Effect is supplied as large pieces which will need to be

broken into 2-3 smaller shards before placing onto the fuel bed. It is

not necessary to use all the supplied Shale Effect.

LOG LAYOUT

LOGS MUST BE POSITIONED ACCORDING TO THE

FOLLOWING INSTRUCTIONS TO GIVE THE CORRECT FLAME

EFFECT.

THE 3 BURNER LOGS MUST LOCATE CORRECTLY ONTO THE

LOG BURNERS. ENSURE THE AMBER EFFECT DOES NOT

CAUSE THE LOGS TO LIFT OFF THE BURNER.

Ensure the Burner Tray and Log Burners are clean and free from

any debris.

The main components are clearly individually labelled.