Reflex 105 Multi-Sided Installation Instructions 1
24
9
10
1
2
NOTE: Take care not to catch any loose wiring previously
disconnected against the front edge of the rebox.
The gas supply enters through the Silicone Panel located on the
left-hand side of the outer box base; this will need to be slit with a
sharp knife prior to passing the supply pipe through.
11
The Isolation Elbow needs to be attached to the gas pipe before
installation, see diagram for location.
Rear Wall
Centre Line
185mm
289mm
Silicone Panel
(Approx location)
Outer Box
12
The appliance stands off the wall by 55mm.
It will be necessary to build a studwork enclosure to house the
mounting bracket and separate enclosures for the upper and lower
faces of the appliance.
WARNING: This appliance weighs 108Kg.
The manufacturer has designed this appliance to
attach to a masonry wall and all xings supplied
reect this. If siting on a studwork wall, the xing
points must be through the timber stud and not
plasterboard. Use appropriate xings.
DO NOT attach solely to a plasterboard wall.
The xings supplied for the Wall Mounted Kit are
R-RBL Rawlbolts and should be tted in the method
described below.
2 3
1
Ensure a minimum substrate thickness of 100mm.
1. Drill a hole - Diameter: 14mm x Depth: 65mm.
Note: When xing into brickwork, mortar joints should
be avoided
Remove debris and thoroughly clean hole with brush
and pump
2. Remove pre-assembled bolt and washer. Insert shield
into hole and tap home with hammer until ush with
surface
3. Insert bolt with washer through xture into the shield
Tighten to 15Nm torque.
Position the wall mounting bracket in the required location.
13