Reflex 105 Multi-Sided Installation Instructions 1

11
INSTALLATION
APPLIANCE LOCATION
This appliance must only be tted into a studwork installation.
This appliance must not be installed in a room that contains a bath or shower.
Combustible parts of the studwork must not be any closer than the minimum dimensions shown in the diagrams. NOTE: These dimensions
must be maintained even if the combustible materials is protected by non-combustible linings.
Do not pack the void around or above the appliance with insulation materials such as mineral wool.
VENTILATION
The installation of this product requires no additional ventilation modications to the building.
However, it will be necessary to ensure the housing for the appliance has vents provided to allow air to circulate and prevent overheating.
This can be done in the form of an installation with a 'Shadow Gap' at the top of the void or with purpose built vents.
If the void is sealed to the oor and/or ceiling is necessary to t a low vent with a minimum free area of 150cm
2
and a high vent of 400cm
2
.
Gazco supplies the following vent options:
Central
POSITION COLOUR CODE
600 x 400 x 60mm LH Corner Open White 991-609
600 x 400 x 60mm LH Corner Open Graphite 991-615
600 x 400 x 60mm RH Corner Open White 991-620
600 x 400 x 60mm RH Corner Open Graphite 991-631
600 x 60mm Central White 991-643
600 x 60mm Central Graphite 991-656
A removable access hatch must be left in the side of the chimney breast for future servicing and inspection of the appliance.
Build the studwork chimney breast to the desired size. Ensure that the clearances to combustible materials is maintained.
SAFETY PRECAUTIONS
For your own and other’s safety, you must install this appliance according to local and national codes of practice. Failure to install the appliance
correctly could lead to prosecution. Read these instructions before installing and using this appliance.
These instructions must be left intact with the user.
Do not attempt to burn rubbish on this appliance.
Keep all plastic bags away from young children.
Do not place any object on or near to the appliance and allow adequate clearance above the appliance.
IF THE APPLIANCE IS EXTINGUISHED OR GOES OUT IN USE, WAIT 3 MINUTES BEFORE ATTEMPTING TO RELIGHT THE
APPLIANCE.
IMPORTANT: REFER TO DATA BADGE AND TECHNICAL SPECIFICATION AT THE FRONT OF THE MANUAL TO ENSURE
THE APPLIANCE IS CORRECTLY ADJUSTED FOR THE GAS TYPE AND CATEGORY APPLICABLE IN THE COUNTRY OF
USE.
FOR DETAILS OF CHANGING BETWEEN GAS TYPES REFER TO SERVICING SECTION REPLACING PARTS.
UNPACKING
Remove the appliance from its packaging, and check that it is complete and undamaged.
Put the loose ceramic parts to one side so that they are not damaged during installation.