Reflex 105 Multi-Sided Installation Instructions 1

10
The Front Glass can now be removed.
Carefully move the front glass into the gap, then lift and manoeuvre
the bottom outwards to remove.
1
2
The side glass does not need to be removed to clean the
appliance.
It is recommended to leave the Side Glass in situ unless
absolutely necessary.
Should the logs require cleaning, lightly brush with a soft brush. Any
large pieces of debris may be removed by hand.
DO NOT USE A VACUUM CLEANER.
Use a damp cloth to clean the outer casing of the appliance.
To clean the glass surface use a non abrasive glass cleaner and
soft cloth.
The glass panel must be retted to the appliance following cleaning
or servicing.
To replace the glass panel, replace in reverse order.
UNDER NO CIRCUMSTANCES SHOULD THE
APPLIANCE BE USED IF ANY OF THE GLASS
PANELS ARE LOOSE, DAMAGED, OR MISSING.
Replace the lower and side trim.
ENSURE THAT ALL GLASS PANELS ARE FLUSH AND THAT
THERE ARE NO GAPS BETWEEN PANELS.
NEVER OPERATE THE APPLIANCE WHEN THE GLASS PANEL
IS REMOVED OR BROKEN.
FLAME FAILURE DEVICE
This is a safety feature incorporated on this appliance which
automatically switches off the gas supply if the pilot goes out and
fails to heat the thermocouple.
IF THIS OCCURS DO NOT ATTEMPT TO RELIGHT THE
APPLIANCE FOR 3 MINUTES.
RUNNING IN
During initial use of a new Gazco appliance a strong odour will be
encountered as various surface coatings become hot for the rst
time. Although these odours are harmless it is recommended that
the appliance is operated on maximum for 4 to 8 hours in order to
fully burn off these coatings. After this period the odours should then
disappear.
If the odours persists, please contact your installer for advice.
During the rst few hours of burning there may be discolouration of
the ames. This will also disappear after a short period of use.
SERVICING
The appliance must be serviced every 12 months by a qualied Gas
Engineer. In all correspondence always quote the Model number
and the Serial number which may be found on the Commissioning
Checklist (Installation Instructions).
INSTALLATION DETAILS
Your installer should have completed the commissioning sheet at
the front of this book. This records the essential installation details
of the appliance. In all correspondence always quote the Model
number and Serial number.
HOT SURFACES
Parts of this appliance become hot during normal use.
Regard all parts of the appliance as a working surface.
Provide a suitable re guard to protect young children and the
inrm.
= Hot
Surface
APPLIANCE WILL NOT LIGHT
If you cannot light the appliance:
Check and change the batteries in the remote handset.
Consult your Gazco retailer or installer if the appliance still does not
light.