Reflex 105 Conventional Flue User Installation Manual

9
User Instructions
Press Reset
Button
LED Status
Blue Power
LED
Function
1 Sec
Continuously
ashes every ½
second
Activates Access Point
Mode for 10mins (connect
MyFire Wi-Fi module to home
network). Simultaneously the
Wi-Fi channel changes.
5 Secs
Two rapid
ashes every 1
second
System Reset.
10 Secs
Flashes
every 100
milliseconds
(Continuous)
Restore factory rmware
(MyFire Wi-Fi module will set
to default after reboot); takes
up to 2 minutes.
20 Secs
Flashes every
50 milliseconds
(Continuous)
Restores factory rmware and
erases all data not locked.
(MyFire Wi-Fi module will set
to default after reboot); takes
up to 2 minutes.
3. Cleaning the Appliance
From time to time it may be necessary to remove build up of
debris and soot from the logs.
3.1 Make sure the appliance and surrounds are cool before
cleaning.
3.2 Remove the glass frame by removing the 2 side trims, see
Diagram 4. These are held on by magnets.
4
3.3 Lift out the bottom slotted trim, see Diagram 5.
5
3.4 Remove the 2 screws at the base of the door,
see Diagram 6.
6
Screws
3.5 Pull up the handle at the front, see Diagram 6.
3.6 Whilst supporting the top, lift the door using the handle, up
and over the lower edge, see Diagram 7.
7
3.7 Should the logs require cleaning, lightly brush with a soft
brush. Any large pieces of debris may be removed by hand.
DO NOT USE A VACUUM CLEANER.
3.8 Use a damp cloth to clean the outer casing of the appliance.
3.9 To clean the glass surface use a non abrasive glass cleaner
and soft cloth.
3.10 The glass frame must be retted to the appliance following
cleaning or servicing.
Ensure that the rope seal on the back of the glass
frame is intact.
3.11 To replace the glass frame, position so the hooks on the
back of the frame t over the side pins, see Diagram 8.
8
3.12 Push the handle down.