Reflex 105 Conventional Flue User Installation Manual
44
19. Replacing the Power Cable
BEFORE UNDERTAKING ANY WORK SWITCH OFF THE
APPLIANCE AND ISOLATE THE POWER SUPPLY
ENSURING THERE IS NO POWER TO THE APPLIANCE.
To replace the Power Cable first remove the Main Control
Assembly, see Section 4.
19.1 Disconnect the 3 cables from the Power Module, See
Diagram 49, arrow A.
NOTE THE CONFIGURATION OF THE WIRES.
49
A
B
19.2 Remove the nuts from the Earth stud and remove the two
Ring Terminals, see Diagram 49, arrow B.
19.3 Remove the 2 screws securing the Power Cable Plate to the
rear of the rebox, see Diagram 50.
50
19.4 Withdraw the old cable.
19.5 Fit the new cable in reverse order ensuring it is rewired in
the original conguration.
Servicing Instructions - Replacing Parts