Reflex 105 Conventional Flue User Installation Manual
43
18. Liners
18.1 There are several lining options available:
Brick Effect
Ledgestone
Black Glass
The Bafe must be removed before the Liners can be taken
out of the appliance, see Section 17.
Remove the Logs, Burners, and Mesh see Section 4.
Once removed the Liners can be taken out.
IMPORTANT: IF THE APPLIANCE IS FITTED WITH
BLACK GLASS LINERS THE BACK PANEL IS ONE
PIECE. THE SIDE PANELS ARE ALSO SPECIFIC FOR
LEFT AND RIGHT - MAKE A NOTE WHEN REMOVING
AND REPLACE IN THE SAME ORIENTATION.
Removing the Side Liners
NOTE: The side liners must be removed before the rear
liner.
18.2 Remove the retention tab securing the liner to the appliance,
see Diagram 44.
44
18.3 Carefully move the liner vertically into the space above, see
Diagram 45.
45
Servicing Instructions - Replacing Parts
18.4 From this position:
1. Move the bottom of the liner out (1).
2. Lower into the space between the side of the
appliance and the control assembly (2).
NOTE: Take care to avoid the LED supports.
46
1.
2.
18.5 Carefully manoeuvre the side liner out of the appliance.
Repeat for the other side.
Removing the Rear Liner
Remove the Side Liners.
18.6 Undo the 6 screws securing the rear liner bracket and
carefully remove, see Diagram 47.
47
18.7 move the liner forwards off the bracket and lower into the
space below.
Once lowered, carefully lift and tilt out of the rebox, see
Diagram 48.
48
18.8 To replace the Liners and Bafe reverse these procedures.
Ensure no amber glass or black shale has fallen onto the
Liner Support Brackets.