Reflex 105 Conventional Flue User Installation Manual

Servicing Instructions - Replacing Parts

6. Module

6.1 Remove the Log Burners, Mesh Tray and Air Guide, see

Section 4.

6.2 Disconnect the LED plug and Mains Lead from the Module,

see Diagram 22.

Mains Lead

Module

Lead

Screw

LED Plug

6.3 Disconnect the Module Lead, see Diagram 22.

6.4 Remove the screw securing the Module to the base of the

appliance, see Diagram 22.

6.5 The Module can now be removed.

6.6 Replace in reverse order.

7. Cross Lighting Injector

7.1 Remove the Log Burners and Main Control Assembly,

see Section 4.

7.2 Undo the nut from the Main Control Assembly,

see Diagram 23 A.

7.3 Undo the nut from the Cross Lighter, see Diagram 23 B.

7.4 Remove the lock nut from the Injector, see Diagram 23 C.

7.5 Replace with the correct size Injector.

7.6 Ensure the left and right hand sides of the Burner engages in

the bracket slots, see Diagram 24.

NOTE: The LH bracket is part of the Pilot bracket.

LH Bracket

RH Bracket

7.7 Check for leaks.

8. Pilot Unit Assembly

IMPORTANT: UNDER THE TERMS OF THE

EXTENDED WARRANTY IT WILL BE COMPULSORY

TO CHANGE THE COMPLETE PILOT UNIT ON THIS

APPLIANCE IN YEARS 2 AND 4.

8.1 The Pilot Assembly needs to be replaced as a complete unit.

8.2 Remove the Log Burners and Main Control Assembly,

see Section 4.

8.3 Remove the Cross Lighting Injector, see Section 7.

8.4 Undo the compression nut from the pilot pipe,

see Diagram 25.

Compression Nut

Ignition Lead

8.5 Remove the 3 screws securing the Pilot Unit,

see Diagram 26.