Reflex 105 Conventional Flue User Installation Manual

Servicing Instructions - Replacing Parts

NOTE: Each board has the wiring direction marked as IN

or OUT on each end to ensure the replacement boards

are wired correctly.

5a.3 Replace in reverse order.

5b. Rear LED Bar

5b.1 To replace the rear LED Board, remove the 4 screws from

the glass bracket, see Diagram 16.

This also secures the rear LED board bracket.

Glass

Remove the glass out of the left hand bracket and place on a

dry, clean surface.

5b.2 Carefully disconnect the wire and undo the 2 screws.

The rear LED board can now be replaced.

Screw

Wire

5b.3 Replace in reverse order ensuring the wires and components

are put back in exactly the same conguration.

When replacing the Long LED board the wires must be

positioned behind the bracket, see Diagram 18.

ENSURE NO WIRES ARE TRAPPED WHEN

REPLACING THE COMPONENTS.

5c. LED Driver

Remove the Main Control Assembly to access the LED

Driver, see Section 4.

5c.1 Disconnect the highlighted wire from the right hand LED

board and carefully feed through the access hole, See

Diagram 19.

LED Plug

Wire

Access Hole

5c.2 Carefully turn the Control Assembly upside down, see

Diagram 20.

NOTE THE POSITION OF THE WIRES.

*Other internal components removed for clarity

Underside of control Assembly

5c.3 Remove the screw in the center of the Driver lip, see

Diagram 21.

Carefully lift the Driver (with cables) off the control assembly

to remove.

5c.4 Replace in reverse order ensuring the components are in the

correct conguration.

ENSURE NO WIRES ARE TRAPPED WHEN

REPLACING THE COMPONENTS.