Reflex 105 Conventional Flue User Installation Manual

36
4.10 Disconnect the isolating device from the appliance inlet pipe
to isolate the gas supply, see Diagram 10.
10
Elbow
4.11 Disconnect the Mains Lead Plug from the Module, see
Diagram 11.
DO NOT REMOVE THE WIRES FROM THE PLUG.
11
Mains Lead Plug
2 Wing Nuts
4.12 Undo the 2 wing nuts, see Diagram 11.
4.13 Lift the Main Control Assembly and remove through the front
of the appliance.
Place carefully to one side.
4.14 Replace in reverse order.
AFTER SERVICING ENSURE THAT ALL
CONNECTIONS ARE REPLACED BEFORE
REPLACING THE MESH TRAY.
5. Replacing the LED Boards
There are 5 LED boards, which can be individually replaced,
see Diagram 12 & 13.
12
LED Driver
Black
Red
Mains Cable
IN
OUT
IN
OUT
1 2
3
4
5
IN
OUT
IN
OUT
13
1
2
3
4
5
NOTE: Ensure the correct orientation when replacing.
THE LED'S ARE FRAGILE. HANDLE WITH CARE.
ONLY HOLD THE LED BOARDS BY THE EDGES TO
AVOID CONTACT WITH THE TOP OF THE LED'S.
AVOID CATCHING ANY DELICATE WIRES WHEN
REPLACING THE SCREWS.
5.1 Remove the Log Burners, Fuel effect, and Mesh tray, see
Section 4.
5.2 Disconnect the LED Mains Lead Plug from the Module, see
Diagram 14.
14
Mains Lead Plug
The LED circuit consists of three components, which can be
individually changed, these are:
5a) Front LED Boards.
5b) Rear LED Bar.
5c) Driver.
5a. Front LED Boards
5a.1 To replace the 4 front and side LED boards remove the
securing screw and disconnect the wires on each side of the
board. The board can now be removed, see Diagram 15.
15
Screw
LED Plug
Module
Wires
5a.2 Repeat for each front LED board.
Servicing Instructions - Replacing Parts