Reflex 105 Conventional Flue User Installation Manual

35
3. Removing the Fuel Effect
The fuel effect consists of 6 different components.
To avoid damage Logs A, B, C, F and M should be removed
in the following order and placed on a dry, clean surface.
3.1 Remove the Log M, see Diagram 5.
3.2 Remove Log B from the Log Burner, see Diagram 5.
5
B
F
M
C
3.3 Remove Log C & F from the Log Burners, see Diagram 5.
3.4 Slide Log A backwards, from under the centre Log Burner, to
remove, see Diagram 6.
6
A
3.5 Remove the remaining components:
1. Large Embers J & H
2. Ember G (x3) & Ember L.
3. Shale Effect.
4. Amber Effect.
Keep each component separate for ease of replacing.
When replacing the fuel effects see Installation Section
11 for layout instructions.
4. Removing the Log Burners
and Main Control Assembly
4.1 To remove the decorative front from the appliance please
refer to the separate instructions supplied.
4.2 Remove the Glass Frame, see Section 2.
4.3 Remove the Fuel Effect, see Section 3.
4.4 Remove the 4 M4x6 screws from the base of the 4 Log
Burners, see Diagram 7.
7
Screws
4.5 Lift the 4 Log Burners to remove.
NOTE: Some burners are pre-tted with Aeration plates.
These are non-serviceable and MUST NOT be altered, see
Diagram 8.
8
4.6 Remove the 3 screws from the front of the Mesh Tray and
the 3 from the rear, see Diagram 9.
9
Rear Screws
Front Screws
4.7 Slide the Mesh Tray forward slightly and carefully lift over the
Log Burner Brackets, Pilot and Cross Lighter.
WHEN REPLACING THE MESH TRAY TAKE CARE NOT
TO DAMAGE THE LOG BURNER BRACKETS, PILOT
AND CROSS LIGHTER.
4.8 Remove through the front of the appliance.
4.9 Turn the gas supply off at the isolation device.
HAVE YOU ISOLATED THE GAS SUPPLY?
Servicing Instructions - Replacing Parts