Reflex 105 Conventional Flue User Installation Manual

29
The Wi-Fi module is now accessible, see Diagram 59.
59
17. MyFire Wi-Fi Set Up & Troubleshooting
17.1 The MyFire Wi-Fi box must be wired according to the
MyFire set up diagram (see Diagram 57) and connected to
the receiver, which is in turn connected to the mains power.
Ensure the device is running the most up to date operating
system as older models may not be compatible with the
MyFire App.
After 30 seconds the MyFire Box goes into Access Point
Mode (Green LED flashes). See MyFire App instructions
supplied and configure the router.
17.2 The following things can affect the Wi-Fi signal on the
appliance:
1. Multiple users on the same Wi-Fi channel may interfere
with the data transfer. Press the reset button on the MyFire
Wi-Fi box for 1 second to change the current channel.
2. If the MyFire Wi-Fi box is not connected to the receiver
or is not used it will leave Access Point Mode after 24
hours.
3. If there are multiple fireplaces in the household using
MyFire Wi-Fi boxes there must be a minimum of 600mm
between them to avoid interference.
4. If there are any changes to the home network then the
MyFire Wi-Fi set up must be repeated.
Quick Reference Table - for LED location see Diagram 54.
LED Indicator for MyFire Wi-Fi box
Label LED Status
Power Blue
On Power On
Off Power Off
WLAN Green
On
Connected to home network
(Wi-Fi Router)
Off
Not connected to home
network (Wi-Fi Router)
Flashing MyFire Wi-Fi Box in Access
Point Mode
Receiver Blue On Receiver connected
Off No receiver connected or
connection lost
All LEDs Flashing Internal Conguration
17.3 It may be necessary to reset the MyFire Wi-Fi box using a
paperclip or similar, see Diagram 60.
The table below shows the length of time required for each
reset and the confirmation signals.
60
Press Reset
Button
LED Status
Blue Power LED
Function
1 Sec
Continuously
ashes every ½
second
Activates AP Mode for
10mins (connect MyFire
Wi-Fi module to home
network). Simultaneously
the Wi-Fi channel changes.
5 Secs
Two rapid ashes
every 1 second
System Reset.
10 Secs
Flashes every
100 milliseconds
(Continuous)
Restore factory rmware
(MyFire Wi-Fi module will
set to default after reboot);
takes up to 2 minutes.
20 Secs
Flashes every
50 milliseconds
(Continuous)
Restores factory rmware
and erases all data not
locked. (MyFire Wi-Fi
module will set to default
after reboot); takes up to 2
minutes.