Reflex 105 Conventional Flue User Installation Manual

28
Installation Instructions
15. MyFire Wi-Fi Installation
Remove the Decorative Front, Glass Panel, Fuel Effect,
Log Burners and Mesh Screen as detailed in the appliance
instructions.
15.1 Secure the velcro pads to the underside of the Wi-Fi
module and position in the allocated position, see
Diagrams 54 & 55.
54
LED'S
55
When satisfied with the position remove the backing from
the velcro pad and secure in place.
Ensure clearance is left between the front edge of the
fire and the Wi-Fi module.
15.2 Using the Wi-Fi cable Connect the Wi-Fi module to the
receiver module, see Diagram 56.
Gazco recommend running the cable along the front edge
of the fire to avoid obstruction of any internal components.
56
15.3 This should complete the wiring circuit as shown, see
Diagram 57.
Wi-Fi
Router
Interrupter Leads
Wi-Fi Module
AUX Lead
57
Valve Lead
Ignition
Cable
Connecting Wire
Lighting
Module
Mains
Lead
Smart Device
Wall Switch Lead
(not applicable)
NOTE: Ensure none of the wires are snagged or caught
on any internal components.
Follow the steps listed in the MyFire App Setup manual
PR2467 to connect a smart device to the fire.
15.4 Replace the Decorative Front, Glass Panel, Fuel Effect,
Log Burners and Mesh Screen.
The installation is now complete.
Once the Wi-Fi module has been installed and
connected to a power source there is a 24 hour
window to complete the setup process on the
MyFire app.
If setup is not completed in this window the Wi-Fi
module will have to be manually reset to complete
setup, see Section 16 & PR2467 MyFire App Setup.
16. Accessing the Wi-Fi Module
Once installed, the Wi-Fi module can be accessed by
following the below instruction.
16.1 Remove the Glass Frame, see Section 3.
16.2 Undo the two screws securing the Wi-Fi Module access
panel and slide across to remove, see Diagram 58.
58