Reflex 105 Conventional Flue User Installation Manual
24
10. Assembling the Fuel Bed
10.1 Carefully lower the Mesh Tray over the Log Burner
Brackets, Pilot and Cross Lighter. Adjust the Mesh Tray so
all screw holes are aligned.
10.2 Replace the 3 screws at the front of the Mesh Tray and the
3 screws at the rear, see Diagram 39.
39
Rear Screws
Front Screws
10.3 Position the far left hand Log Burner so that the right hand
side is angled up towards the centre of the rebox and the
screw hole is positioned at the front, see Diagram 40.
40
Screws
10.4 Position the centre right hand Log Burner so that the left
hand side is angled up towards the centre of the rebox and
the screw hole is positioned at the front, see Diagram 40.
NOTE: THIS BURNER IS SHORTER THAN THE OTHER
THREE.
10.5 Position the centre left and far right Log Burners, so that the
screw holes are positioned at the front, see Diagram 40.
10.6 Secure the burners with the 4 screws provided, see
Diagram 40.
Only use M4x6 Screws to secure the burners.
NOTE: Some burners are pre-tted with Aeration plates.
These are non-serviceable and MUST NOT be altered.
Installation Instructions
11. Arrangement of Fuel Bed Components
Advice on handling and disposal
of fire ceramics
The fuel effect and side panels in this appliance
are made from Refractory Ceramic Fibre (RCF),
a material which is commonly used for this
application.
Protective clothing is not required when handling
these articles, but we recommend you follow
normal hygiene rules of not smoking, eating or
drinking in the work area and always wash your
hands before eating or drinking.
To ensure that the release of RCF bres are kept
to a minimum, during installation and servicing
a HEPA ltered vacuum is recommended to
remove any dust accumulated in and around the
appliance before and after working on it. When
servicing the appliance it is recommended that
the replaced items are not broken up, but are
sealed within heavy duty polythene bags and
labelled as RCF waste.
RCF waste is classed as stable, non-reactive
hazardous waste and may be disposed of at a
licensed landll site.
Excessive exposure to these materials may
cause temporary irritation to eyes, skin and
respiratory tract; wash hands thoroughly after
handling the material.
TAKE CARE NOT TO SPILL THE FUEL EFFECT INTO
THE PILOT AREA.
ONLY GENUINE GAZCO PARTS CAN BE USED IN THIS
APPLIANCE.
Use the majority of the supplied Amber Effect. It is not a
requirement to use all of the supplied effect.
The Shale Effect is supplied as large pieces which will
need to be broken into 2-3 smaller shards before placing
onto the fuel bed. It is not necessary to use all the supplied
Shale Effect.