Reflex 105 Conventional Flue User Installation Manual

Installation Instructions

To Finish the Installation

After commissioning:

6.6 Finish the sides of the chimney breast, see Diagram 27.

A removable access hatch must be left in the side of the

chimney breast for future servicing and inspection of the

appliance.

7. Fitting the Liners

BAFFLE

7.1 To do this undo the 5 screws securing it to the roof of the

rebox, see Diagram 28.

Screws

7.2 The Bafe can now be removed by lowering the front edge

and pulling forward through the front of the appliance.

TAKE CARE NOT TO DAMAGE THE SIDE PANELS.

7.3 When replacing the Bafe ensure that the 2 tabs t into the

slots either side of the rear liner bracket, see

Diagrams 29 & 30.

Fitting the Rear Liner

NOTE: The rear liner must be tted before the side liners.

7.4 Remove the 6 screws securing the rear liner bracket to the

back of the appliance, see Diagram 31.

7.5 Carefully place the bottom of the liner onto the rear liner lip

and tilt upwards into position, see Diagram 32.

7.6 Secure the Rear Liner Bracket using 6 screws, see

Diagram 33.