Reflex 105 Balanced Flue User Installation Manual
48
Servicing Instructions - Replacing Parts
17.9 Once in position, tilt the Liner forwards and carefully
manoeuvre out of the rebox, see Diagram 48.
48
17.10 To replace the Liners and Bafe reverse these procedures.
Ensure no amber glass or black shale has fallen onto the
Liner Support Brackets.
18. Replacing the Power Cable
BEFORE UNDERTAKING ANY WORK SWITCH OFF THE
APPLIANCE AND ISOLATE THE POWER SUPPLY
ENSURING THERE IS NO POWER TO THE APPLIANCE.
To replace the Power Cable first remove the Main Control
Assembly, see Section 4.
18.1 Disconnect the 3 cables from the Power Module, See
Diagram 49, arrow A.
NOTE THE CONFIGURATION OF THE WIRES.
49
A
B
18.2 Remove the nuts from the Earth stud and remove the two
Ring Terminals, see Diagram 49, arrow B.
18.3 Remove the 2 screws securing the Power Cable Plate to
the rear of the rebox, see Diagram 50.
50
18.4 Withdraw the old cable.
18.5 Fit the new cable in reverse order ensuring it is rewired in
the original conguration.