Reflex 105 Balanced Flue User Installation Manual
47
Servicing Instructions - Replacing Parts
17. Liners
17.1 There are several lining options available:
Brick Effect
Ledgestone
Black Glass
The Bafe must be removed before the Liners can be taken
out of the appliance, see Section 16.
Remove the Logs and Burners, see Section 4.
Once removed the Liners can be taken out.
IMPORTANT: IF THE APPLIANCE IS FITTED WITH
BLACK GLASS LINERS THE BACK PANEL IS ONE
PIECE. THE SIDE PANELS ARE ALSO SPECIFIC FOR
LEFT AND RIGHT - MAKE A NOTE WHEN REMOVING
AND REPLACE IN THE SAME ORIENTATION.
To remove the side liners:
17.2 Undo the 2 screws and remove the Side Liner Brackets, see
Diagram 42.
42
Black Glass & Brick Effect Side Liners:
17.3 Move the top of the liner towards the centre of the rebox and
carefully manoeuvre out of the appliance, see Diagram 43.
43
Ledgestone Side Liners:
17.4 Move the liner vertically towards the top of the rebox, see
Diagram 44.
44
17.5 Move the front edge of the liner towards the centre of the
rebox and carefully manoeuvre out of the appliance, see
Diagram 45.
45
To remove the rear Liner:
17.6 Remove the Side Liners.
17.7 Undo the 4 screws securing the rear liner bracket and
remove, see Diagram 46.
46
17.8 Slide the right hand side of the Rear Liner as far forward as
possible, see Diagram 47.
47