Reflex 105 Balanced Flue User Installation Manual

40
4.7 Carefully lift the Mesh Tray over the Log Burner Brackets,
Pilot and Cross Lighter.
WHEN REPLACING THE MESH TRAY TAKE CARE NOT
TO DAMAGE THE LOG BURNER BRACKETS, PILOT
AND CROSS LIGHTER. REPLACE THE FRONT SCREWS
FIRST BEFORE TIGHTENING THE REAR SCREWS.
4.8 Remove through the front of the appliance.
4.9 Remove the 6 screws to remove the Access Panel,
see Diagram 10.
10
Screws
4.10 Turn the gas supply off at the isolation device.
HAVE YOU ISOLATED THE GAS SUPPLY?
4.11 Disconnect the isolating device from the appliance inlet pipe
to isolate the gas supply, see Diagram 11.
11
Elbow
4.12 Remove the remaining screws securing the Main Control
Assembly to the rebox, see Diagram 12.
12
Power Module
Wi-Fi Module
4.13 Remove the screw from the module bracket and carefully lift
to remove, see Diagram 13.
13
Screw
4.14 Disconnect the LED lead and the Receiver lead from the
power module, if tted, disconnect the Wi-Fi lead from the
Wi-Fi module (positioned left of the power module).
The Main Control Assembly can now be removed.
4.15 Replace in reverse order.
AFTER SERVICING ENSURE THAT ALL
CONNECTIONS ARE REPLACED BEFORE
REPLACING THE MESH TRAY.
5. Replacing the LED Circuit
There are 5 LED boards, which can be replaced
individually, see Diagrams 14 & 15.
14
LED Driver
Black
Red
Mains Cable
IN
OUT
IN
OUT
1 2
3
4
5
IN
OUT
IN
OUT
15
1
2
3
4
5
NOTE: Ensure the correct orientation when replacing.
Servicing Instructions - Replacing Parts