Reflex 105 Balanced Flue User Installation Manual
38
1. General
1.1 All main components can be replaced without removing the
appliance from its installation.
1.2 DISCONNECT MAINS ELECTRICAL SUPPLY AT THE
ACCESSIBLE PLUG OR DEDICATED SWITCH BEFORE
SERVICING THE APPLIANCE.
IT IS ESSENTIAL THAT THE GAS SUPPLY TO THE
APPLIANCE IS TURNED OFF AT THE ISOLATION
DEVICE BEFORE PROCEEDING FURTHER.
1.3 It will be necessary to remove the complete burner module
before any of the components can be serviced.
DURING SERVICING OF THIS APPLIANCE IT MAY
BE NECESSARY TO CUT CABLE TIES IN ORDER
TO ACCESS AND REMOVE SOME OF THE PARTS.
THESE MUST BE REPLACED WHEN
REASSEMBLING THE APPLIANCE.
AFTER SERVICING ENSURE THAT ALL
CONNECTIONS ARE REPLACED BEFORE
REPLACING THE MESH TRAY.
2. Removing the Glass Frame
2.1 To remove the decorative front from the appliance please
refer to the separate instructions supplied with the front.
2.2 Remove the glass frame by removing the 2 side trims, see
Diagram 1. These are held on by magnets.
1
2.3 Lift out the bottom slotted trim, see Diagram 2.
2
2.4 Remove the 3 screws at the base of the door, see Diagram 3.
3
Screws
2.5 Pull up the handle at the front, see Diagram 3.
2.6 Whilst supporting the top, lift the door using the handle, up
and over the lower edge, see Diagram 4.
4
When re๎tting the glass frame ensure that the rope seal
on the back of the frame is intact.
2.7 To replace the glass frame, position so the hooks on the
back of the frame ๎t over the side pins, see Diagram 4.
2.8 Push the handle down.
2.9 Replace the screws. As the screws are tightened the glass
frame is pulled down against the hooks and forms a seal.
Replace ALL of the securing screws ensuring that a
screw is present in all ๎xing slots.
UNDER NO CIRCUMSTANCES SHOULD THE
APPLIANCE BE USED IF ANY OF THE GLASS
FRAME RETAINING SCREWS ARE LOOSE OR
MISSING.
2.10 Replace the lower trim.
2.11 Replace the 2 magnetic side trims.
NEVER OPERATE THE APPLIANCE WHEN THE GLASS
PANEL IS REMOVED OR BROKEN.
2.12 The glass frame must be re๎tted to the appliance following
cleaning or servicing.
Servicing Instructions - Replacing Parts