Reflex 105 Balanced Flue User Installation Manual

32
Installation Instructions
16. MyFire Wi-Fi Installation
16.1 Remove the Glass Frame, see Servicing Instructions,
Section 2.
16.2 Remove the Main Burners, Mesh, and Control Assembly,
see Servicing Instructions, Section 4.
16.3 Carefully turn the Control Assembly over and connect the
module lead to the receiver, see Diagram 54.
54
16.4 Replace the Control Assembly ensuring the module lead
runs under the aperture, see Diagram 55.
55
16.5 Carefully position the Wi-Fi Module in the module bracket,
ensuring the correct orientation, see Diagram 57.
Connect the module lead to the Wi-Fi module, see
Diagram 56.
56
NOTE: Ensure none of the wires are snagged or caught
on any internal components.
16.6 This should complete the wiring circuit as shown, see
Diagram 57.
Wi-Fi
Router
Interrupter Leads
Wi-Fi Module
AUX Lead
57
Valve Lead
Ignition
Cable
Connecting Wire
Lighting
Module
Mains
Lead
Smart Device
Wall Switch Lead
(not applicable)
LED's
Follow the steps listed in the MyFire App Setup manual
PR2467 to connect a smart device to the fire.
16.7 Replace the Glass Frame and trims.
The installation is now complete.
Once the Wi-Fi module has been installed and
connected to a power source there is a 24 hour
window to complete the setup process on the
MyFire app.
If setup is not completed in this window the Wi-Fi
module will have to be manually reset to complete
setup, see Section 16 & PR2467 MyFire App Setup.
Once tted, remove the trims and the glass frame to access
the Wi-Fi module.