Reflex 105 Balanced Flue User Installation Manual
30
Installation Instructions
13.11 Place Log F on the right hand Log burner in the position
shown in Diagram 47.
47
F
C
13.12 Place the Log M on the left hand side of the fuel bed with
the right hand end positioned in the groove on Log A, see
Diagram 48.
Position Large Ember J on the left hand side, leaving a gap
between the ember and the side panel.
48
J
M
13.13 Place the cutout of nal Ember G against the right hand Log
Burner bracket, and the small ember between logs B & C,
see Diagram 49.
DO NOT PLACE EMBERS OVER THE BURNER.
49
G
Ember
G
EMBER
13.14 Spread the remaining amber effect between the logs and
embers to cover the fuel bed.
13.15 Evenly spread a small amount of the shale effect across the
mesh bed to ll any gaps, see Diagram 50.
It is not necessary to use all the supplied Shale Effect.
50
14. Completion of Assembly
Ensure that the rope seal on the back of the glass
frame is intact.
14.1 To replace the glass frame, position so the hooks on the
back of the frame t over the side pins, see Diagram 51.
51
14.2 Push the handle down.
14.3 Replace the screws. As the screws are tightened the glass
frame is pulled down against the hooks and forms a seal.
Replace ALL of the securing screws ensuring that a
screw is present in all xing slots.
UNDER NO CIRCUMSTANCES SHOULD THE
APPLIANCE BE USED IF ANY OF THE GLASS FRAME
RETAINING SCREWS ARE LOOSE OR MISSING.
14.4 Replace the lower trim.
14.5 Replace the 2 magnetic side trims.
NEVER OPERATE THE APPLIANCE WHEN THE GLASS
PANEL IS REMOVED OR BROKEN.
14.6 Replace the decorative front by referring to the separate
leaet supplied with the front.
NOTE: ENSURE THAT THE LOGS ARE POSITIONED AS
ABOVE. ONLY USE THE CORRECT AMOUNT OF LOGS
AS SPECIFIED IN THE DIAGRAMS.
15. Lighting the Appliance
The appliance is operated by thermostatic and
programmable remote control.
52