Reflex 105 Balanced Flue User Installation Manual

29
Installation Instructions
TAKE CARE NOT TO SPILL THE FUEL EFFECT INTO
THE PILOT OR CROSS LIGHTER AREA.
ONLY GENUINE GAZCO PARTS CAN BE USED IN THIS
APPLIANCE.
Use the entirety of supplied Amber Effect.
The Shale Effect is supplied as large pieces which will
need to be broken into 2-3 smaller shards before placing
onto the fuel bed. It is not necessary to use all the supplied
Shale Effect.
13. Log Layout
LOGS MUST BE POSITIONED ACCORDING TO THE
FOLLOWING INSTRUCTIONS TO GIVE THE CORRECT
FLAME EFFECT.
THE 4 BURNER LOGS MUST LOCATE CORRECTLY
ONTO THE LOG BURNERS. ENSURE THE AMBER
EFFECT DOES NOT CAUSE THE LOGS TO LIFT OFF
THE BURNER.
13.1 Ensure the Burner Tray and Log Burners are clean and free
from any debris.
13.2 The main components are clearly individually labelled.
13.3 Place the Large Ember H on the right hand side of the fuel
bed, see Diagram 41.
41
H
L
G
G
42
L
G
G
G
G
L
13.4 Place the cutout of Ember G against the left hand Log
Burner bracket, in the position shown in Diagrams 42.
13.5 Place the cutout of the second Ember G against the
centre left Log Burner bracket, in the position shown in
Diagrams 42.
13.6 Place the cutout of Ember L around front of the Pilot,
see Diagrams 42.
13.7 Evenly spread some of the amber effect across the mesh
bed, leaving space under the lower edge of the Log Burners,
see Diagram 43.
43
13.8 From the back carefully slide Log A under the left hand side
of the centre Log Burner, see Diagram 44.
44
A
13.9 Place Log B on the centre left Log Burner in the position
shown in Diagram 45.
45
B
13.10 Place Log C on the centre right hand Log Burner in the
position shown in Diagram 46.
46
B
C