Reflex 105 Balanced Flue User Installation Manual

27
Installation Instructions
Ledgestone Side Liners:
8.9 Lift the liner and angle the rear edge into the rear corner of
the rebox, see Diagram 33, Arrow A.
33
A
B
Level the liner so it sits at against the side of the appliance,
see Diagram 33, Arrow B.
8.10 Lower the liner so it rests in the liner lip, see Diagram 34.
34
All Models:
8.11 Place the side liner brackets in position and x in place, see
Diagram 35.
35
Repeat for both sides.
9. Fitting the Main Control Assembly
Please note: If you intend to install a MyFire Wi-Fi
App with the Reex 105 it is easier to attach the wire
for the receiver box at this stage.
The module and wires for the App can be tted after
installation but access is easier with the Control Box
exposed.
See Section 16 for details.
9.1 Carefully tilt the front of the Main Control Assembly into
the appliance ensuring the LED cable and Receiver cable
are fed under the front of the rebox aperture and are not
trapped.
NOTE: If tting a Wi-Fi module, the Wi-Fi cable must also
be fed under the rebox aperture.
Lower the rear of the Control Assembly into position.
36
9.2 Reconnect the Receiver Lead to the Module, see
Diagram 36.
9.3 Secure the Main Control Assembly with the following
screws, see Diagram 37.
NOTE: The centre screw must be tted rst to set the
alignment, see Diagram 37 A.
37
A
9.4 Connect power and the gas supply to the appliance.