Reflex 105 Balanced Flue User Installation Manual

Installation Instructions

To Finish the Installation

After commissioning:

7.20 Finish the sides of the chimney breast, see Diagram 26.

A removable access hatch must be left in the side of the

chimney breast for future servicing and inspection of the

appliance.

8. Fitting the Liners

IMPORTANT: IF THE APPLIANCE IS FITTED WITH

BLACK GLASS LINERS THE BACK PANEL IS ONE

PIECE. THE SIDE PANELS ARE ALSO SPECIFIC FOR

LEFT AND RIGHT - MAKE A NOTE WHEN REMOVING

AND REPLACE IN THE SAME ORIENTATION.

Bafe

8.1 The Bafe must be removed before the Liners can be tted

in the appliance.

8.2 Undo the 5 screws securing the bafe to the roof of the

rebox, see Diagram 27.

Screws

8.3 The Bafe can now be removed by lowering the front edge

and pulling forward through the front of the appliance.

TAKE CARE NOT TO DAMAGE THE SIDE PANELS.

8.4 NOTE: When replacing the Bafe ensure that the 3 tabs t

into the slots in the rear liner bracket, see Diagram 28.

Top View

Fitting the Rear Liner

NOTE: The rear liner must be tted before the side liners.

8.5 Remove the 4 screws securing the rear liner bracket to the

back of the appliance, see Diagram 29.

8.6 Carefully place the bottom of the liner onto the rear liner lip

and tilt upwards into position, see Diagram 30.

8.7 Secure the Rear Liner Bracket using 4 screws, see

Diagram 31.

Fitting the Side Liners

NOTE: The side liners must be tted after the rear liner.

Black Glass & Brick Effect Side Liners:

8.8 Carefully place the bottom of the liner onto the side liner lip

and tilt upwards into position, see Diagram 32.