Reflex 105 Balanced Flue User Installation Manual

21
Installation Instructions
3.11 Mark around the ue, see Diagram 2.
2
10mm
A wall plate is supplied to x the ue to the wall:
3.12 Bend the tab to 90°.
3.13 Assemble the plate onto the ue but do not secure to wall
until the ue is fully assembled.
3.14 The cardboard tment in the terminal is used to support the
ue whilst it is cut to length. ONCE CUT TO SIZE REMOVE
THE CARDBOARD REMNANT, see Diagram 3.
3
4. Removing the Glass Frame
4.1 Remove the glass door by removing the 2 side trims, see
Diagram 4. These are held on by magnets.
4
4.2 Lift out the bottom slotted trim, see Diagram 5.
5
4.3 Remove the 3 screws at the base of the door, see Diagram 6.
6
Screws
4.4 Pull up the handle at the front, see Diagram 6.
4.5 Whilst supporting the top, lift the door using the handle, up
and over the lower edge, see Diagram 7.
7
4.6 Remove the 2 boxes from the appliance and store safely as
they contain the Log Burners and fuel effects.