Reflex 105 Balanced Flue User Installation Manual
16
Installation Instructions
2. Flue Options
2A. Top Flue Up and Out Kit
(999-026/999-026AN)
2a
Start of bend to centre line of horizontal ue 170mm. Centre
line of vertical ue to end of bend 220mm.
2.1 Vertical from the top of the appliance then horizontally out,
see Diagram 2a. The basic kit comprises:
1 x 1000mm terminal length
1 x 200mm vertical length
1 x 90 degree elbow
1 x Wall plate
1 x 60mm restrictor
1 x 70mm restrictor
4 x Fixing screw
This kit provides the minimum materials. Extra lengths can
be added to the vertical and horizontal sections;
see Section 3.
Refer to Installation Instructions, Technical Specication on
page 12 to identify when to use a restrictor.
If a vertical height of 1000mm is to be used then a Rear
Terminal must be tted, see Section 2b.
2b
2B. Top Flue Up and Out Terminal Kit
(999-044/999-044AN)
NOTE: ONLY USE WITH VERTICAL LENGTH OF
1000MM AND HORIZONTAL LENGTH OF UP TO 600MM.
2c
Start of bend to centre line of horizontal ue 170mm. Centre
line of vertical ue to end of bend 220mm.
2.2 Vertical from the top of the appliance then horizontally out,
see Diagram 2c. The basic kit comprises:
1 x 90 degree elbow
1 x 1000mm terminal length
1 x Wall plate
4 x Fixing screw
Refer to Installation Instructions, Technical Specication on
page 12 to identify when to use a restrictor.
If a vertical height of 1000mm is to be used then a Rear
Terminal must be tted.
2d
Terminal dimensions:
395 x 200 x 200 mm (H x W x D)
Guard supplied
Cut to length as required on site.
Site Requirements