Reflex 105 Balanced Flue Installation Instructions

37
ELECTRODE
Pull the ignition lead off the electrode and undo the retaining nut,
see arrow A.
A
B
C
3
Replace with a new electrode. Do not over-tighten the nut; this
could break the component.
Replace the ignition lead.
PILOT INJECTOR
With the pilot assembly removed, undo the nut to drop the injector
out from the burner, see Arrow B.
THERMOCOUPLE
Undo the brass nut to remove the thermocouple from the pilot
burner unit, see Arrow C.
IGNITION LEAD
Unplug the Ignition lead from the control box.
Ignition Lead
Carefully cut cable ties from the vidaflex and disconnect the lead
from the electrode.
IMPORTANT Ensure not to cut the cables.
NOTE: When replacing, ensure the ignition lead does not run
across the control box.
CROSS LIGHTING INJECTOR
Remove the Log Burners and Main Control Assembly.
Turn the Main Control Assembly over to access the components on
the underside.
Remove the injector pipe by loosening the two nuts.
1
Undo the nut from the Cross Lighter.
2
SERVICING INSTRUCTIONS