Reflex 105 Balanced Flue Installation Instructions

35
SERVICING INSTRUCTIONS
Disconnect the LED Mains Lead Plug from the Module.
LED wires
2
The LED circuit consists of three components, which can be
individually changed, these are:
Front LED Boards.
Rear LED Bar.
Driver.
Front LED board
LED boards 1 - 4 are accessible through the Main Control
Assembly.
Remove the corresponding screws securing the glass covers and
remove.
1
Screw
Clip
Clip
2
Repeat for each front LED board.
NOTE: Each board has the wiring direction marked as IN or
OUT on each end to ensure the replacement boards are wired
correctly.
Replace the module bracket and glass covers in reverse order
Withdraw the module and disconnect the LED Mains Lead Plug.
Rear LED board
Remove the Main Control Assembly to access the Rear LED Bar
(LED board 5).
Remove the 2 screws securing the LED cradle to the underside of
the Control Assembly.
Screw
Screw
*Other internal components removed for clarity
3
Carefully withdraw the cradle and remove the wiring connection
from the left hand side.
*Other internal components removed for clarity
4
Undo the 2 screws securing the board and replace in reverse
order.
LED Driver
Remove the Main Control Assembly to access the LED Driver.
The Driver is located on the underside of the Control Assembly next
to the latching solenoid.
Remove the screw in the center of the Driver lip.
Carefully lift the Driver (with cables) off the control assembly to
remove.
5
Replace in reverse order ensuring the components are in the
correct configuration.
ENSURE NO WIRES ARE TRAPPED WHEN
REPLACING THE COMPONENTS.