Reflex 105 Balanced Flue Installation Instructions

34
SERVICING INSTRUCTIONS
Disconnect the LED lead and the Receiver lead from the power
module. If tted, disconnect the Wi-Fi lead from the Wi-Fi module.
Lift the rear and slide to the right.
The Main Control Assembly can now be removed.
Replace in reverse order.
AFTER SERVICING ENSURE THAT ALL
CONNECTIONS ARE REPLACED BEFORE
REPLACING THE MESH TRAY.
REPLACING THE LED CIRCUIT
There are 5 LED boards, which can be replaced individually.
LED Driver
Black
Red
Mains Cable
IN
OUT
IN
OUT
1 2
3
4
5
IN
OUT
IN
OUT
1
2
3
4
5
THE LED'S ARE FRAGILE. HANDLE WITH CARE.
ONLY HOLD THE LED BOARDS BY THE EDGES TO
AVOID CONTACT WITH THE TOP OF THE LED'S.
AVOID CATCHING ANY DELICATE WIRES WHEN
REPLACING THE SCREWS.
Remove the Log Burners, Fuel effect, and Mesh tray.
Remove the screw from the module bracket and lift out carefully.
Screw
1
Screws
4
Turn the gas supply off at the isolation device.
HAVE YOU ISOLATED THE GAS SUPPLY?
Disconnect the isolating device from the appliance inlet pipe (A) to
isolate the gas supply.
Elbow
5
A
Remove the remaining screws securing the Main Control Assembly
to the rebox.
Power Module
Wi-Fi Module
6
Remove the screw from the module bracket and carefully lift to
remove.
Screw
7