Reflex 105 Balanced Flue Installation Instructions
27
INSTALLATION INSTRUCTIONS
MYFIRE WI-FI SET UP &
TROUBLESHOOTING
The MyFire Wi-Fi box must be wired according to the MyFire
set up diagram and connected to the receiver, which is in turn
connected to the mains power.
Ensure the device is running the most up to date operating system
as older models may not be compatible with the MyFire App.
After 30 seconds the MyFire Box goes into Access Point Mode
(Green LED flashes). See MyFire App instructions supplied and
configure the router.
The following things can affect the Wi-Fi signal on the appliance:
1. Multiple users on the same Wi-Fi channel may interfere with
the data transfer. Press the reset button on the MyFire Wi-Fi
box for 1 second to change the current channel.
2. If the MyFire Wi-Fi box is not connected to the receiver or is
not used it will leave Access Point Mode after 24 hours.
3. If there are multiple fireplaces in the household using
MyFire Wi-Fi boxes there must be a minimum of 600mm
between them to avoid interference.
4. If there are any changes to the home network then the
MyFire Wi-Fi set up must be repeated.
Quick Reference Table.
LED Indicator for MyFire Wi-Fi box
Label LED Status
Power Blue
On Power On
Off Power Off
WLAN Green
On
Connected to home network
(Wi-Fi Router)
Off
Not connected to home
network (Wi-Fi Router)
Flashing MyFire Wi-Fi Box in Access
Point Mode
Receiver Blue On Receiver connected
Off No receiver connected or
connection lost
All LEDs Flashing Internal Conguration
It may be necessary to reset the MyFire Wi-Fi box using a
paperclip or similar.
The table below shows the length of time required for each reset
and the confirmation signals.
Press Reset
Button
LED Status
Blue Power LED
Function
1 Sec
Continuously
ashes every ½
second
Activates Access Point
Mode for 10mins (connect
MyFire Wi-Fi module
to home network).
Simultaneously the Wi-Fi
channel changes.
5 Secs
Two rapid ashes
every 1 second
System Reset.
10 Secs
Flashes every
100 milliseconds
(Continuous)
Restore factory rmware
(MyFire Wi-Fi module will
set to default after reboot);
takes up to 2 minutes.
20 Secs
Flashes every
50 milliseconds
(Continuous)
Restores factory rmware
and erases all data not
locked. (MyFire Wi-Fi
module will set to default
after reboot); takes up to 2
minutes.