Reflex 105 Balanced Flue Installation Instructions

26
INSTALLATION INSTRUCTIONS
MYFIRE WI-FI INSTALLATION
BEFORE UNDERTAKING ANY WORK SWITCH OFF THE
APPLIANCE AND ISOLATE THE POWER SUPPLY ENSURING
THERE IS NO POWER TO THE APPLIANCE.
Remove the Main Burners, Mesh, and Control Assembly, see
Servicing Instructions.
Carefully turn the Control Assembly over and connect the module
lead to the receiver.
1
Replace the Control Assembly ensuring the module lead runs under
the aperture.
2
Carefully position the Wi-Fi Module in the module bracket, ensuring
the correct orientation.
Connect the module lead to the Wi-Fi module.
56
3
NOTE: Ensure none of the wires are snagged or caught on any
internal components.
This should complete the wiring circuit as shown.
Wi-Fi
Router
Interrupter Leads
Wi-Fi Module
AUX Lead
Valve Lead
Ignition
Cable
Connecting Wire
Lighting
Module
Mains
Lead
Smart Device
Wall Switch Lead
(not applicable)
5
Follow the steps listed in the MyFire App Setup manual
PR2467 to connect a smart device to the fire.
Replace the Glass Frame and trims.
The installation is now complete.
Once the Wi-Fi module has been installed and
connected to a power source there is a 24 hour
window to complete the setup process on the
MyFire app.
If setup is not completed in this window the Wi-Fi
module will have to be manually reset to complete
setup, see Section 17 & PR2467 MyFire App Setup.
Once tted, remove the trims and the glass frame to access the
Wi-Fi module.