Reflex 105 Balanced Flue Installation Instructions

INSTALLATION INSTRUCTIONS

PRE-INSTALLATION

Disconnect the Mains Lead Plug, the LED leads and the receiver

lead from the Module and the Wi-Fi box (if installed).

DO NOT REMOVE THE WIRES FROM THE PLUG.

LED wires

Module wires

Remove the remaining screws securing the Main Control

Assembly to the rebox.

Lift the rear of the Main Control Assembly and rotate upwards

slightly to clear the gas valve and remove through the front of the

appliance.

NOTE: Take care not to catch any loose wiring previously

disconnected against the front edge of the rebox.

Place carefully to one side.

The gas supply enters through the Silicone Panel located on the

left-hand rear of the outer box; this will need to be slit with a sharp

knife prior to passing the supply pipe through.

Note: The Isolation Elbow needs to be attached to the gas pipe

before installation.