MyFire Wifi Retro Fitting Kit

Installation Instructions
2.8 Replace the Main Burners and Fuel Effect, see PR2272
(Conventional ue).
3. Accessing the WiFi Module
Once installed, the WiFi module can be accessed by
following the below instruction.
3.1 If Fitted, remove the Glass Frame, see PR2272, Servicing
Instructions, Section 2.
3.2 Remove the two screws securing the service hatch and
slide across, see Diagram 11.
11
The WiFi module is now accessible, see Diagram 12.
12
Follow the steps listed in the MyFire App Setup manual
PR2467 to connect a smart device to the re.
Once connected, replace the service hatch in reverse order.
3.3 Replace the Glass Frame, see PR2272.
The installation is now complete.
Once the WiFi module has been installed and
connected to a power source there is a 24 hour window
to complete the setup process on the MyFire app.
If setup is not completed in this time the WiFi module
will have to be manually reset to complete setup, see
the installation instructions supplied with the appliance.
Gazco Limited, Osprey Road, Sowton Industrial Estate, Exeter, Devon, England EX2 7JG
Technical Customer Services: [phone] Fax: [phone]
E-mail: [e-mail]
A member of the Stovax Group
E & O E
Wiring Diagram
Mains Power In
Earth
LED
Pilot Burner
Control Value
Thermocouple
Solenoid
Valve
Solenoid
Supply Lead
Control Valve
Supply
Control Box
Electric Module
Light
Supply
Ignition Lead
TC
Lead
SW
Lead
Mains Adapter Lead
WiFi Module