MyFire Wifi Retro Fitting Kit

3
Installation Instructions
2.3 Secure the velcro pads to the underside of the WiFi module
and position in the allocated position, see Diagrams 4 & 5.
4
5
When satisfied with the position remove the backing from
the velcro pad and secure in place.
Ensure the WiFi module butts up to the folded return
beside the LED bar & clearance is left between the front
edge of the fire and the WiFi module.
2.4 Using the WiFi cable Connect the WiFi module to the
receiver module, see Diagram 6.
Gazco recommend running the cable along the front edge of
the fire to avoid obstruction of any internal components.
6
2.5 Feed the mains adapter lead through the rear left-hand
panel (alongside the gas supply) and towards the front edge
of the firebox, see Diagram 7. Insert the lead into the
allocated slot on the receiver module.
Ensure the wire does not obstruct any internal
components.
7
*Access panel removed for clarity
NOTE: Ensure none of the wires are snagged or caught
on any internal components.
2.6 Slide the service hatch onto the air guide and secure with
screws provided, see Diagrams 8 & 9.
8
9
2.7 Rotate and slide the air guide into position with the ends
locating under the side brackets.
Ensure that the angled metal is sloping towards the front of
the appliance.
10