MyFire Wifi Retro Fitting Kit

2
1.6 Remove the 2 screws from the front of the Mesh Tray, see
Diagram 2.
2
Rear Screws
Front Screws
1.7 Loosen the 3 screws at the rear of the Mesh Tray, see
Diagram 2.
1.8 Slide the Mesh Tray forward slightly to disengage from the
rear screws and carefully lift over the Log Burner Brackets,
Pilot and Cross Lighter.
WHEN REPLACING THE MESH TRAY TAKE CARE NOT
TO DAMAGE THE LOG BURNER BRACKETS, PILOT
AND CROSS LIGHTER. REPLACE THE FRONT SCREWS
FIRST BEFORE TIGHTENING THE REAR SCREWS.
1.9 Remove through the front of the appliance.
TO CONTINUE PLEASE REFER TO THE APPROPRIATE
FITTING METHOD FOR THE INSTALLATION TYPE.
2. Fitting the WiFi Module
Refer to Section 1 to remove the Log Burners and Mesh.
2.1 Remove the 2 screws from the Air Guide, see Diagram 3.
3
Front Screws
2.2 Lift and rotate the Air Guide upwards from the front edge to
remove.
Note the orientation for reassembly of the new air guide.
Installation Instructions
General
This manual has been designed to show the installation
methods available to t a MyFire WiFi module to the
Reex 75T.
Please carefully read in conjunction with the Installation
Instructions for the Reex 75T (PR2272) making sure the
appropriate method is understood before attempting to install
the product.
DISCONNECT MAINS ELECTRICAL SUPPLY AT THE
ACCESSIBLE PLUG OR DEDICATED SWITCH BEFORE
SERVICING THE APPLIANCE.
IT IS ESSENTIAL THAT THE GAS SUPPLY TO THE
APPLIANCE IS TURNED OFF AT THE ISOLATION DEVICE
BEFORE PROCEEDING FURTHER.
Kit Contents
1 x WiFi Module
1 x WiFi Cable
1 x Replacement Air Guide
1 x Air Guide Service Hatch
2 x Screws
2 x Velcro Pads
2 x Instruction Manuals
1 x WiFi mains adapter lead
1. Removing the Log Burners and Mesh
1.1 To remove the decorative front from the appliance please
refer to the separate instructions supplied.
1.2 Remove the Glass Frame, see PR2272, Servicing
Instructions, Section 2.
1.3 Remove the Fuel Effect, see PR2272, Servicing Instructions,
Section 3.
1.4 Remove the 3 screws from the base of the 3 Log Burners,
see Diagram 1.
1
Screws
1.5 Lift the 3 Log Burners to remove.