Hearth Slips Installation User Instructions

3
Installation Instructions
1. Installation
Hearth
One of the most important starting points for the
successful installation of this mantel is to ensure that
thehearthisaslevelaspossibleandformsa90˚angle
to the fireplace opening.
1.1 If a new hearth is being laid, place on a complete bed of
lime based mortar.
NOTE: If laying a light coloured stone hearth use a light
coloured silver sand to prevent marks coming through the
stone.
1.2 Centralise the hearth to the centre line of the appliance.
The hearth must meet the requirements of the Building
Regulations and be suitable for the type of heating appliance
to be installed.
Slips
1.3 Checkthatthebottomsliptsbetweentheapplianceedge
andthehearth,seeDiagram1,ArrowA.Donotxinplace.
Ensure that the bottom slip is level, vertically and
horizontally, between the hearth and the appliance and the
sidesnishushtotheedges.
1.4 Remove the bottom slip.
1.5 Place the side slips, ensuring that they butt up against the
edgeoftheapplianceandareushfromtoptobottom,see
Diagram 1, Arrow B.
1.6 Bond the slips to the wall using a suitable adhesive.
1.7 Place the top slip, ensuring that it butts up against the top
edge of the appliance and sits centrally on the side slips, see
Diagram 1, Arrow C.
1.8 Bond the slip to the wall using a suitable adhesive.
1.9 Replacethebottomslip,ensuringthatitstilltsasdescribed
in step 1.3, see Diagram 1, Arrow A.
1.10 Bond the slip to the wall using a suitable adhesive.
1.11 RefertotheStoneMantelInstallationInstructionsandfixthe
back of the Stone Mantel to the slip and wall face.
2. Cleaning
Cleaning the Hearth and Slip set:
2.1 Use a damp, soft cloth to clean the surface.
Do not use any cleaning agents.
Hearth
Appliance
Edge
Mantel
A
B
B
C
1
Riva2 750HL Model Shown