Gazco MyFire App
14
User Instructions
6. Program Mode
Each of 8 programs can be set to go ON and OFF at specic times at set temperatures.
Select the Program Mode symbol from the menu on the left hand side (press tab to reveal) or the short cut on the right hand side.
1. Ensure that the appliance is switched on.
2. Select Program Mode from the left sidebar.
3. To change days, times, or ON/OFF temperature, touch the program number (circle 1).
4. Touch the section of the setting wheel to be changed (time, temp, day). Change the setting.
NOTE: Green sections are start time and temperature. Red sections are end time and temperature.
5. Conrm your changes by touching the yellow checkmark.
Turn ON desired Program (1 – 8) once setup by touching the power button.
NOTE: To delete a program, touch that program number and go to program settings. Touch red CLEAR button and then touch the red check mark.
NOTE: A warning message will pop-up if programs overlap.
7. EcoFlex Mode
Automatic Energy Saving Mode
Corresponds to the set temperature in Thermostatic Mode.
1. Touch/slide auto temperature button next to ame button to ON.
If the room temperature is lower than the set temperature, the ame height stays on high for a longer period of time.
If the room temperature is higher than the set temperature, the ame height stays on low for a longer period of time.
2. Choose the time button (15min, 20min, or 25min). The percentage of energy saved is shown in the circle/leaf.
NOTE: A shorter time cycle results in a more active ame picture.
Note: The location of the menu and icons may vary depending
on the control device used.
Save energy while enjoying a changing, realistic ame picture.
Select the EcoFlex Mode symbol from the menu on the left hand side (press tab to reveal).
1. Select EcoFlex Mode from the left sidebar.
2. Choose between low re, medium re, and high re.
3. Choose time button (15min, 20min, or 25min). The percentage of energy saved is shown in the circle/
leaf.
NOTE: A shorter time cycle results in a more active ame picture.