Conventional Flue

8
User Instructions
7. Log Layout
LOGS MUST BE POSITIONED ACCORDING TO THE
FOLLOWING INSTRUCTIONS TO GIVE THE CORRECT
FLAME EFFECT.
All logs can be identied by a letter (A - D) on their
underside. Logs A and B have holes to locate each onto a
burner stud.
7.1 Ensure the burner tray is clean and free from any debris, see
Diagram 10.
Note: The burner trays are visually different, depending on
the model, but the log layouts are the same.
10
Midi/ Midi Midline Nat Gas Burner shown
(Midi/ Midi Midline
Nat Gas only)
7.2 Place Log A in position on the 2 locating pins,
see Diagram 11.
11
A
Midi/ Midi Midline Nat Gas Burner shown
7.3 Spread the Lava Rock evenly over the fuel bed and around
Log A, see Diagram 12.
Ensure that the fuel effect does not obstruct the pilot.
12
Midi/ Midi Midline Nat Gas Burner shown
7.4 Position the 2 embers on the lip at the front of the fuel bed,
see Diagram 13.
13
Midi/ Midi Midline Nat Gas Burner shown
7.5 Log B is positioned on the right hand locating pin, and rests
against the back liner, see Diagram 14.
Midi/ Midi Midline Nat Gas only: Log B also rests on the rear
burner bracket.
14
B
7.6 Log C rests on Log A and the front tray with the locating pin
facing up, see Diagram 15.
15
C